Dear support team,
I have installed the igyro 3e of my rc jet in combination with the jetmunt 140XBL turbine.
The gyro is connected to ailerons (Hitec 7955TG), elevators (Hitec 7955TG) and rudder (MKS6130HV)
When the turbine is off, all surfaces respond as expected, whatever the gain setting.
When the turbine is running (idle or high thrust), all surfaces respond as expected when the gain is set at zero.
When the turbine is running at high thrust , all surfaces respond as expected when the gain is set to a normal gain value (60%) but the rudder servo shows spurious movement (a kind of jitter every 4 or 5 seconds)
The ECU of the turbine (Xicoy V10) is located 15cm from the gyro and the rudder servo cable is separated from turbine/pump cables
Would you please help me to understand rudder servo behaviour?
Thank you in advance for your support.