New to power box and unable to update

  • Good evening.


    I have an exciting project a Skymaster A-10 EDF jet!!!


    I have most of the hardware installed and thought I would give the powerbox setup a go tonight.


    I have read through the forums and the instructions a couple of times but seem to be stuck.


    I have a Jeti DS-16 with Rex7 and R3 receivers. They are not connected to the power box. I will connect them when I update the unit.


    I have a Powerbox Royal SRS.


    I have a charged battery connected to the unit and the display screen and buttons show power. I connected the included USB connector to the computer after the unit was powered. The USB is connected to the TELE port with the negative lead on the bottom. The program registers that there is something there but then gives an error.. It says "no powerbox-device connected".


    Please let me know if there is something else I need to do or if there is something I am doing wrong.


    EDIT


    I am running windows 10 on a Microsoft surface pro computer.


    Thank you.


    EDIT times two....


    I'm an idiot. I did not realize I had to set the unit to allow computer control. All is good now. The unit is updating.