I ned to set-up my new PB Competition in my 35% Extra with following devices:
PB competition programmed for 7,4V
Rx futaba 6208 (powered by PB @ 7,4V)
HV digital servos Hitec 7954SH (powered by PB @ 7,4V), two on each ailerion, one for each stab and one for rudder.
The Rx should be set at "High speed mode" (I believe) because I'm using digital servo (even if not Futaba brands). Is this correct ?
Ok, as Hitec does not declare the recomended servo frame rates, my question is: which is the correct frame rate to be set on PB to avoid servo performance decreasing and, in the same time, to avoid servo overclocking with a too high frame rate. What can you suggest as starting point value ?
Thanks in advance