Jeti triple link

  • Hello Gabriel,

    the trick is to use an Jeti EnLink. (Use the PPM-Firmware in this case!)

    One 2.4GHz Rx is connected directly to the PB.

    The second one and the 900MHz Rx are both connected to the Enlink.

    And finally the EnLink output is connected to the PB second Rx input.

    Additional you have to power the two RX with separate 2 wire cables out of the PB.


    This worked flawlessly.


    Ingmar

  • Richard,

    I understand there are two possibilities to Connect 2x2.4Rx and one 900Rx to Mercury; Always one Rx to Mercury RX1, then; Alternative 1 with the use of EnLink to RX2 and alternative 2 (the one you described over, and foto) with the 900 into a Rx and from there to Mercury RX2.

    So I have two questions:

    a) Are there any differences in safety between alternative 1(EnLink) and 2 900->Rx->Rx2. Will the switch over strategy be the same for these two alternatives

    b) How is switch over strategy between RX1 and RX2 in the Mercury. Will it mostly use only RX1 and only switch to RX2 if RX1 is really bad, or will it jump between Rx1 and 2 picking the best datapackages at all time. Is it possible to do any customer adjustments to this in the Mercury, or is it al set from PB?


    Thanks