iGYRO with GPS firmware not updating.

  • Igyro SRS v16 with GPS.



    Hello,


    I cannot get the iGYRO to connect with the terminal program on the laptop its not seen. (I have updated 2 Mercury's and a Baselog so I know that the program and adapter cable is OK) Also the iGYRO does not see its GPS sensor. Have tried this GPS sensor on a Mercury and it is seen. Also tried the Mercury's GPS sensor on the iGYRO and it was not seen. It seems that the GPS/DATA input is not working. The led on the GPS sensor flashes slow to start and then speeds up when connected to the iGYRO.




    Any suggestions?




    George.

  • Hello,


    the GPS is only seen when a receiver signal is there.. But ok- if you selected PC-Control and you cannot find the Gyro, it really seems to be something bad.

    If you don´t find something else, please send it to us for a check.

  • Hello,


    the GPS is only seen when a receiver signal is there.. But ok- if you selected PC-Control and you cannot find the Gyro, it really seems to be something bad.

    If you don´t find something else, please send it to us for a check.

    I will try it with a receiver in circuit. And let you know.


    George.

  • Hello,


    the GPS is only seen when a receiver signal is there.. But ok- if you selected PC-Control and you cannot find the Gyro, it really seems to be something bad.

    If you don´t find something else, please send it to us for a check.

    Hello,

    I have tried it with a receiver and it is still the same.


    George.