I had a fire under my turbine from some un burnt fuel as I was doing a run up test on the ground. Unfortunately I had run the 3 wires going to the elevators and rudder under the turbine and when the insulation melted I had nice shorts but I didn't see any smoke anywhere up front by the powerbox. After the fire was out I noticed the jet was not responding to any commands the receivers did not have power nothing would work. When I got home I unplugged the 2 elevator wires and the rudder wire from the powerbox. I powered up the powerbox and everything is working fine. I proceeded to plug a servo into the rudder and 2 elevators sockets on the powerbox and the servo worked fine in each. Do you think the powerbox is ok or should it be sent in to be checked out.
I have attached a copy of the burnt wires.