VERS 17.9 GEAR DOOR POSITION ADJUSTMENT

  • Richard,

    I have used mode 2 on gear doors for Panther. It gas main doors and front doors. Front doors on C and mains on F.

    The front door servos are buzzing a bit are are too closed. I suspect I can adjust this in the task menu instead of re setting the whole program. I show a screen shot from the display and I am trying to adjust task six to do the above by changing the start position from 1500 to less. However nothing happens and I am doing it wrong so can you guide me please. The gear is UP which you can see from the display. I did see another post about timing but you said don't adjust positions so I am a bit nervous which is why I am asking.

    Thank you

    Missing the search subject panel from the forum

  • Hello,


    so please look in your TASK 3, you can change the values there. Take care that the values are identical for DOWN->UP are the same as UP->DOWN

    You can also post here what values you see when you select TASK 3. I can help you then.


    Mode 2:


    Direction: DOWN- > UP (Retract landing gear)


    Task 1...........open right door

    Task 2...........open left door

    Task 4...........switch valve

    Task 3...........close 1. front door

    Task 7...........close 2. front door

    Task 5...........close right door

    Task 6...........close left door


    Direction: UP- > DOWN (Extend landing gear)


    Task 1...........open right door

    Task 2...........open left door

    Task 3...........open 1. front door

    Task 7...........open 2. front door

    Task 4...........switch valve

    Task 5...........close right door

    Task 6...........close left door