I would like to utilize two FUTABA R7008SB on the Mikrocopter V3.0 Flight Controller to take advantage of the Futaba 14SG control link redundancy. Is this possible?
From the diagram I see where both receivers plug in but where does the S.BUS connector from the flight controller plug into the Power Expander? MISC. PORT?
The MIKROCOPTER FC 3.0 provides 5V. Is this enough to power the Power Expander or do I need to provide additional power to the Power Expander?
As you can see from the MIKROCOPTER WIKI, I will need tp use a S.BUS Signal Inverter. Here is the link on how to connect a receiver to the V3.0 Flight Controller.
Thank you in advance!