I have to made maiden flight with new jet+2 axle vector(vector no under Igyro).
Igyro v16, dsx9 radio, standard configuration(no delta)
I haven't enough channels so I'll set Igyro with standard test flight assistance procedure then I remove aux channel to use it for vector.
When I run 2 axle vector Igyro switch to FM3 and heading mode of rud, elev and aile in this flight condition is “0”
Obviously I lost the advantages of rudder heading (knife edge, slow rolls, etc) but I have the advantage of “normal” during vector flight.
Have you some suggestion or different setup ?