Hello PowerBox team,
I need to clarify some points regarding the FLY TEST ASSISTANT procedure and Flight Mode configuration performed during Setup Assistant:
During Setup assistant, I have defined the FM through a 3 position switch as follows:
- Switch UP FM1: Rate Mode
- Switch Neutral FM2: OFF
- Switch Down FM3: Att. Assist.
By doing that I ensure commonality with other plane fitted with Igyro 3e with:
- Rate Mode range 0 to +100%,
- OFF at 0%
But now, when launching Fly Test Assistant, Mercury asks to switch to FM2 and gain at 0% and then increase gain during flight.
With my configuration FM2 is OFF so I do not activate the Gyro and Fly Test Assistant is not performed as expected.
As I don't want to perform Setup assistant again and loose all the defined settings, what is the way to proceed to Fly Test in such configuration?
Is it possible to fly and adjust the gain thanks to Input Mapping and Rotary knob instead of Fly Test Assistant?
What will be the consequence if the self-calibration of the gyro sensors, and the reset of the maximum permitted control surface travels is not done through the Fly Test assistant?
Thank you in advance for your usual support.