Hi I am using Blue Com IOS on an Ipad
Mobile Terminal V1.9
Igyro 1e V3 software
I would like to ajust the servo centre point on output 2
The initialization and servo reverse all work fine
I use the transmitter stick to move the servo to the required position and press start
After pressing start button the Mobile Terminal completely shuts down and the radio stops working ( servos wont move)
I switch the radio off then on again and the servo goes back to its original position
I have tried this with 2 Igyro 1e and both do the same.
is there a video showing step by step how to do this ?