I recently have installed a igyro 3e in a turbine model for very simple use during flight when needed. Have it setup on a 3 position switch with middle selection off , forward for normal and aft for what I thought would be heading mode, the gain is set using the laptop terminal program. My light indication is all green (fwd), off (center), all green (aft), for the three switch position on my Futaba radio. So for some reason I am not getting any red lights in my heading hold positon. gyro orientation and direction seem to be ok. What am I missing or not doing correctly as far as what I was assuming should be seeing some red lights in hold mode? I am also using a Gps II sensor.
Thanks for your help.