I would like to know if the following behaviour is normal, while using flight assistant on the ground before setting it up for the flight test..
Here is the set up: Igyro SRS+GPS+Powerbox competitionSRS with futaba T18MZ and 2 6308SB receivers.
In order to use 3 savox 1230 servos on the (huge) rudder of an Ultimate, I selected "digital OUT" to have the possibility to use rudder A (with 2 servos+matching) and rudder B with the third servo. I have a permanent prog mix on the radio to mix rudder A servos and rudder B servo.
I have one switch for the gain and one switch for flight mode and they are correctly seen by the gyro.
Here is my trouble: when I use flight assistant, the programmation for rudder A is NOT duplicated for rudder B.
After using the assistant, having a look at gyro settings, all rudder A elements (FM0,1,2) are OK, but all rudder B elements (FM0,1,2) are forced at 0: is that normal?
I can manually put all the elements on the rudder B settings afterwards, BUT it means that I can't use flight assistant in the air (at least for rudder parameters), as the rudder B servo won't move like the 2 others.