Early version BaseLog

  • Hi Richard, I have two BaseLog units, not sure how old but manual only describes Multiplex and Spektrum telemetry. Also nothing described about update possibilities. When entering setup on the units, the screen lists this; Chemistry, Capacity, MSB-Mode, Output-voltage and OK. I tried to connect PC/PB Terminal to the MSB plug on the BaseLog, but the PB Terminal could not detect the BaseLog (as expected since i could not set the unit into PC/Update mode). I guess I have two older units. Can theese be updatet to be Jeti telemetry capable. If i need to send to you what is the time duration and cost for this?


  • Hi Richard, I was thinking; is it possible that I bring with the two Baselog units to the JetPower Event in September and that you perform the sw update there at the Event. It would save me time and shipping cost. Is it possible?

  • Richard, yes i know (also that the PB stand is very bussy and popular at the JP).

    OK, I will bring with my two BaseLogs, and you will se what you are able to do.


    Thanks again for superquick reply :-)