I have had the V2 smoke pump for some time. I'm using a Futaba 14SG transmitter. As the manual explains:
This version of the software was supplied between 2010 and 10/2014. The pump
controller behaves like a conventional speed controller:
Transmitter -100% » pump off
Transmitter +100% » full pump power
a) You wish to set 30% pump power; this is the usual requirement for petrol engines.
For this the transmitter travel has to be set up as follows:
- 100% pump off
- 60% pump on
With most transmitters this is only possible by setting up a mixer, since the upper
limit of travel cannot be set to a value below 0%. Our Expert Forum includes suggested
solutions for various radio control systems.
Can someone help me with the mix required to be able to adjust the full range of the pump?