hello Help x connection
I just bought a gyro srs and in the manual I read that it must be connected in the s / bus port of the receiver.
i want to try gyro in an old model that has a futaba r617fs receiver .... is it possible ??
Sorry for my english translated with google
Hello,
no - this receiver doesn´t work: no S.BUS output
OK thanks .
I understand very little the English language, you do not have an Italian translation of the instruction manual ??
No - I´m sorry
Hi
I have some problems to set the gyro:
I followed all the instructions of the assistante setup but the servos do not work, where am I wrong ??
Hello,
first of all you have to use output 8 of the receiver and set it to S.BUS (Mode B)
Then you have to set the iGyro to S.BUS
Then use the setup assistant to set it up
Thanks for your help
sorry but I can't figure out how to set the gyro on this screen, so it doesn't work
Yes- it looks like you have no correct signal. As I told you you have to set the receiver to ModeB. The S.BUS is on output 8
the receiver is in mode b with s / bus in channel 8, but it does not work in the right way, with the gyro installed as in the photo as you need to set the direction (right / left, up / down) ???
Yes- this mounting direction setting is correct
English
