Posts by Enry

    ...thanks.
    I connected the iGyro in pin RX2 of the Central Box.
    Question: how do I program the TX so that through the only exit-output-pin ( in this example: RX2) to pass the commands to elevator, aileron und rudder?
    Ciao.
    Enry

    Good Morning,
    I have buy your iGyro SRS with GPS this Juli 204.


    I own a Jeti DC 16 (FW 3.00) + Central Box 200 with two Duplex Rsat 2x (FW3.22).


    I connected the two RSAT in outputs-pins RX1 and RX2 of the Central Box 200.


    I have set the TX: Double Path mode.


    I have set the receivers (RSAT1 and RSAT2):
    Output mode: Ex Bus & PPM Positive
    No. channels 16
    Output period: 14 ms
    Failsafe : disabled


    In your previous post you say: "connect ouput of the SAT receiver with BUS1 BUS2 or from the iGyro " but the outputs-pins SAT, in Central Box 200, is already occupied by RSAT 1 and RSAT2.


    Question: in which the output-pin of the Central Box 200 I have to connect iGyro?


    IGyro will be materially connected with the Central Box only through one (01) exit-output-pin. Through this exit-outpunt-pin will leave the controls for: elevator, aileron und rudder.


    Question: how do I program the TX so that through the only exit-output-pin to pass the commands to elevator, aileron und rudder?


    Sorry for the perhaps trivial questions and for my English!


    Thanks for the reply.


    Enry Altoè


    ITALY