Posts by SP250

    Thanks Richard


    I had already set the RX12 DR Pro receiver to SRXL, but had not allocated a servo channel to the FM switch at the transmitter.

    My error for not understanding the MPX programming.


    John M

    Hello Richard


    No Channels are moving except throttle, which is conncted direct into the RX. 2 ele, 2ail and rudd all into gyro.

    RX has been updated to srxl on one B/D input and patch lead from RX to Gyro is connected.

    Cannot make switch go to 105% or -105% because it is the flight mode switch - does not have ability in TX to alter % like in a servo control.

    It is either pos 1, pos 2 or pos 3 thats it.


    John M

    I can't get past the iGYRO sensing the switch for the flight modes in the set up assistant..

    Have tried it with MPX Royal Pro Tx and also my new Profi TX.

    The iGYRO can't sense the FM switch on either Tx.

    I tried different switches too - but no go.

    It can only sense the 4 main stick axes, but of course that is no use.

    It does sense the GPS sensor.

    Please advise.


    John M

    I am just about to use a Gemini Mk 1 which is new in box and never used. I purchased it a few years ago.

    Will it be ok with LiFe batteries, or can I only use LiPo or NiMh as per the instructions?


    Also can the Gyro 5.3V output be used to feed a ZDZ ignition for an RV 80?

    Or should I use a separate 5 cell NiMh to keep the ignition isolated.

    Model is a large glider tug.


    Thanks

    John M