Posts by mustafasari

    hello,


    i have mercury srs v08 and two futaba receivers as 6308sbt. according to manual of mercury, i have to plug the rx cable to ch 8 sbus and change the receiver mode B or D.

    i have read the futaba 6308 manual and it says the same for sbus.

    finally i tried 50 or more times but there is no rx status on mercury. both rx1 and rx 2 are empty (-)


    receivers are both in normal mode ( speed ) and channel mode has been tried both mode B and D


    also i am sure that the receivers are in mode b or d because when i change the mode to A ( channel 8 is normal ) i plug the servo to ch 8 and it works but when i change the mode to B (channel 8 is sbus only) i plug the servo to ch 8 it does not work. so any suggestion


    thanks