- Radio System - S.BUS2
- RX1 connected to SBUS2
- TELE (not currently used)
- Default FASSTest mode
- SBUS.2 port -> SR2
- Telemetry reload; Select PowerBox in slot 16
The issue is we are not seeing any PowerBox SR2 telemetry values (voltage, capacity, etc.). We do see Rx voltage.
- is setup correct?
- Is the SR2 telemetry stream passed over RX1 connection using S.BUS2 or do I need to connect the SR2 TELE? If so where do I connect?
- what telemetry values does SR2 support over S.BUS2?
- is TELEconverter required?