I've just completed the conversion of three planes from Futaba to Core. So far, the process has been very smooth. I'm very happy with my decision to shift vendors.
I do have a question related to servo speed. I have been testing the use of run time under the function menu for this. But the settings effect on the surface appears to be directly related to the travel percentage setting. Which presents itself as a problem if you have asymmetrical travel between positions. Example, if I set position 1 to 20% travel and position 2 to 60%, and I set the run time to 4 seconds for both <- and ->, the result is a slower speed for the lower rate position. I tried to work around this by setting different run time values for both <- & ->, but there is always a small differential between the two positions. I hope my question makes sense and I am not missing something related to the use of run time. Any help would be appreciated.
Alternatively, how are you adjusting servo speed on asymmetric servo curves? Worse case scenario would be for me to adjust the speed in the servos, but I would prefer to adjust this in the radio.
Thanks in advance.