hi i am trying to connect the teleconverter with the powerbox terminal but i get the massage no powerbox device is conected and i am doing everything right what is rong thanks
teleconverter problems
-
-
Hello,
did you power it with a battery? Pls make a photo of your connections. -
hi yes i power the teleconverter with battery ,from the side that is powerbox i connect the usb and from the side s-bus the battery i open the powerbox terminal and then i plug the usb connected with teleconverte and battery as manual says,
-
Hello,
try this sequence:
- connect USB to computer
- connect USB and Teleconverter
- connect battery
- open PowerBox Terminal
- select "Teleconverter"
- press "Next" -
hello nothing happens the some masage any other advice thanks
-
Please check if you have connected the "PowerBox" output with your USB-Adapter.
It will not work if you connect the "S-Bus" connector to your USB-Adapter.Please also post a picture of your connection, as Richard suggested before.
-
The connections are corect usb to pwerbox side battery to sbus side
-
Please send me your full address with PM, we will send you a new one in advance.
-
Thank you very much your support is excellent i will send you my adress
-
Dear sir i have send to you compleete addresse and phone number if is anything you need send a pm thanks
-
Hello,good evening.
I've also done those same steps,and I couldn't register my Teleconverter.
What should I do?
Regards,
Fernando. -
-
Hello,
I've done those same steps again and it didn't work.
Regards,
Fernando. -
Hello,
pls send me your adress with PM- we will send you a new one.