Hello
I'm unable to register the Teleconverter with the 14 SG.
Teleconverter is at latest firmware and communicates with terminal program.
14 SG is at Rev 6.0C - I have tried two 14SGs
I have reset the telemetry data and tried reloading which seems to complete but no Powerbox sensors appear in the list. Using register function gives 'Communication error' message.
The teleconverter is powered up with a charged battery per the diagram i.e. at the Powerbox end/lead.
Please advise.
Regards
Dave
Hello,
are you able to make setting in the teleconverter with the Terminal and USB?
Hello Richard,
Yes the terminal & USB functions normal with teleconverter
Regards
Dave
Hello,
did you try several times? We have this issue sometimes. The customer then gets a new on. When we test the old one in the factory it works flawless... So in 99% of all cases it´s just a question of trying it again and again.
Richard,
I have tried many times - I will try a few more.
Dave
Richard,
After very many attempts and swapping batteries I managed to register and now have telemetry via the Mercury and teleconverter.
I may have to but another one now....
Thanks
Dave
Hello,
thanks for not giving up. It´s really much work supporting teleconverter problems because Futaba has different registering bugs in the different telemetry transmitters...
English
