How to - Empfängerupdates in den Core einspielen & Wireless Update

Where are the English versions of all these videos?

Flugass,

Please can you help me with a small problem.

Most of my installations are 2 x 26D receivers into a PB Competition/Mercury/Royal SRS unit and when I try to update them from the CORE, I always have one that needs to be rescued. Why is this?

1. Is it because both receivers are bound to the CORE when I do the update?

2. Should I unplug one receiver and only have one bound when I do the update?

3. Then if I have to do a rescue of one, do I only plug that receiver into the PB unit?

To avoid this problem I have removed the receivers completely from the model and updated them from my PC with the PB Terminal and then re-installed them again in my model. But of course I realise that this should not be necessary if I did it correctly from the CORE.

JanR

when I remember correctly WLAN Update of receivers works only smooth if only one reciever is bound

Hello,

works with two receivers bound as well. If one update crashes you should be able to rescue it from the radio. That works very well. But for the rescue: yes- only one must be connected.

Thanks Richard, I will try it again.