I have read through the forums as well as the instruction book for the Royal SRS and wanted to confirm my understanding of the setup for my Futaba setup using two futaba 7014 receivers since it has been a long time since I used a powerbox. I am not sure what software I have since I have not powered the powerbox up yet. The signal controller serial number is 303118 and display controller serial is 304254
1. Receiver SB/DG2 port should be set to Sbus and connection from receiver to Powerbox must utilize this channel? I cannot use the SBus2 port for powerbox connection if I wanted to use DG2?
2. Futaba shows 3 modes for speed on the receiver (FASSTest, FAAST normal, and FAAST high speed) Will the Faastest work or must I change it to FAAST normal?
3. All servos go into powerbox, no servos go directly into receiver regardless of what they are used for? For example if I have a separate door sequencer can that be plugged in directly to receiver?
4. If I have already set all the servos endpoints and throws in the radio I can select the direct option for 1-18 in the powerbox. How do I utilize the igyro function if I set all the powerbox channels as "direct"? I have 2 aileron servos, 2 elevator servos, and a rudder all on separate channels that I would like to have gyro for.
With this setup using two batteries, I would have battery and receiver redundancy correct?