What kind of cables should have a servo in the case of digitalization HV servos are more than 40kg in addition to torsional and the wires are long (160cm) sufficient to 22AWG wires?
Is soldering the wires to continue the best option when I want to minimize the amount of servo connectors?
Why powerbox only provide 7.4V voltage servo and not the full 8.4V lipo 2 cell system it would be possible to get?
Running on the current receiver Powerbox for each channel along the cable which it set?
Can those cables to be replaced with longer and stronger lines, whether the strength of the cable make a difference?
I have selected a channel to control the ignition kill switch, it is a type of opto-separated and ON / OFF. Kill switches will be 3 wires I choose channel power box allowing, do I have to disconnect from that of + hub off the main power from the battery to the ignition pass the Powerbox?
Here are a few questions, I hope to meet you holding up all these. thank you