Just for a test: can you turn off servo 4 and 5 and then teach the sticks new?
Oh - and take it out of the channel assignement in the Pioneer
Posts by Richard Deutsch
-
-
Is this with the BlueCom or USB?
-
You must power the RX side and connect the bluecom
-
Hello,
for this you better work with flightmodes. There is a fade in time which affects to all functions
-
Hallo,
natürlich - genauso universell wie alles im Core!
-
ZEEB:
1. If you are only complaining and not interested in giving me informations to help you, I´m out here - o.k.?
2. You started complaining about all things here instead of asking how to fix your problem - this is not how it works here!
3. If you threat me again to go into social media and badmouth about PowerBox because you are not happy with our products or service I will block your account!
-
There must be something wrong- this is a digital software thing. If it works at all other people it must work also in your plane!
Please post a picture of your channel assignement from the Pioneer
And again check the channels in your radio and write me that list here.
-
Die Differenzierung ist getestet und kommen nächste Woche!
-
Hallo,
können auch ganz raus - würde aber einfach kucken ab wann sich der Spanner nicht mehr bewegt und sie dann so stehen lassen
-
Hello,
with only RX connected? There must be something really wrong in your wiring - this two parts have physically no contact inside.
Yes- if your ignition you need only the tacho signal on the third pin
-
Hallo,
kucken Sie mal bei der Trimmung ob da "Reverse" eingetragen ist
-
Please teach the mounting position as written above. Move the plane 2-3x up and down last move up. (the surfaces move in any direction - don´t care)
Then move the plane left and right 2-3x, last move right. (direction of the surface doesn´t matter)
It MUST work - everybody else has no issues. Also take care to hold the stick while you teach the stick position
-
Hello,
then you have to assign in the output mapping L to Direct XX (Channel number of switch A from the radio)
Set the Switch A channel to 0% to +100%
-
Hallo,
das sind dann eher die Lager wenn sonst nichts locker ist. Das können wir aber nur bei uns beheben
-
Hello,
if the LED light is there - there is also power on the connector because the LED is directly taking it´s power from the output connector.
Please check iif you really connected it with the right polaisation
-
I hope we can fix everything next week
-
Hello,
the SparkSwitch is simply connected with a Y-harness to the receiver 1 (telemtry receiver)
You have to upgrade the software if you want to get the telemetry
-
Again:
Aileron A - 2 right outer delta
Elevator A - 3 left outer delta
4 - inner elevator right
5 - inner elevator left
The surfaces must work correctly when you control it with the radio. Also when you teach the mounting position, move the plane 2-3x up and down and then 2-3x left and right
It works 100% - there are hundreds of installations out there
-
Hello,
the GPSII doesn´t work at all on the Fasttrack!! This protocoll is not implemented.
What you see is not a failure - If the GPS has no signal the gyro is reduced to a minimum!
Just go outside, wait until the GPS has greeen light and you will see that it works!
-
