Mercury SRS software V8
Jeti ds16 TX
REX9 on primary
Rex3 on secondary
Evrythings works as expected, however:
Ch6 on tx is assigned to 2 position switch
Reading the output on Channel 6 in tx, 1000, 2000 ms
Reading the output of Channel 6 in REX9, 1000, 2000 ms
reading the ouput of mapped output c (mapped DIRECT); 1041, 2062 ms
Is this normal ?
I am planning to install the unit on a plane that is properly trimmed and I know the exact values that my servos should be receiving. I
f this "shift" is normal, I can adjust end travels TX to match the desired values?