Dashboard
Recent Activities
-
ASW 20
Replied to the thread V04 Micro Vario mit TEK Anschluß.PostIch betreibe ein Micro Vario vom SM,
funktioniert tadellos auch die Geschindigkeitsanzeige
Thomas -
Aalfawaz
Posted the thread Pioneer + Futaba 7003SB + Cortex Pro.ThreadHi all,
I recently installed a pioneer in jet with two 7003SB receivers and a cortex pro in serial.
At the beginning I could not get the pro to recognize the signal no matter how many times I tried. Until I figured I would connect everything to the S.Bus… -
Rudolf
Replied to the thread Pioneer nach Update V8.0 ohne Funktion.PostOh that's bad! You can in some cases burn USB Adapter if servos connected to Pioneer, and in that case is connection not stable, and that's a reason why crashed.
First of all, connect accu to Pioneer and switch on the Pioneer, then start Terminal, connect… -
ThomasP
Replied to the thread Pioneer nach Update V8.0 ohne Funktion.PostThank you for your respone Rudi,
but do I have to power up the Pioneer with the switch?
I only connected by USB interface which provides the power. There is no Accu connected.
Regards
Tom -
Rudolf
Replied to the thread Pioneer nach Update V8.0 ohne Funktion.Posthello,
never wait more than 3 minutes! If the update stuck, then some communication problem occurred, abort the process, disconnect Pioneer from the power, exit Terminal, power up Pioneer again, start Terminal and do Rescue.
Rudi -
ThomasP
Replied to the thread Pioneer nach Update V8.0 ohne Funktion.PostHallo,
kann jemand sagen wie lange das Update der Pioneer Box ungefähr dauert?
Bei mir läuft es bereits seit über 2 Std über das USB Interface und ist bei 42%.
Grüße Thomas -
Richard Deutsch
Replied to the thread V10 Multiplex M-Link Probleme beim Verbinden mit RX-16-DR MASTER und MERCURY SRS / Software Version V11.PostHallo,
also mit SRXL V1 muss das auf jeden Fall gehen. Die Mercury auf M-Link. -
Hardrock Wings
Replied to the thread V10 Multiplex M-Link Probleme beim Verbinden mit RX-16-DR MASTER und MERCURY SRS / Software Version V11.PostIch habe nur die Software 1.0.1. zur Verfügung, ein anderer Softwarestand wird mir nicht vom Launscher angeboten. Es werden nur zwei Ausgangs Möglichkeiten SRXL V1, SRXL V2 angeboten und SRXL V1 Diversity als Eingang. Hab schon alle Möglichkeiten… -
Richard Deutsch
Replied to the thread V10 Multiplex M-Link Probleme beim Verbinden mit RX-16-DR MASTER und MERCURY SRS / Software Version V11.PostWird Ihnen auch andere Empfängersoftware im Launcher angeboten? Soweit ich mich errinnere muss die 1.26 funktionieren mit SRXLV1 -
Richard Deutsch
PostHello,
in any software version you should have 9,12,15,18,21 - always!
As F-Schlepp says: it depends on your servos. 12ms works for most modern servos